This is XTOOL
PS90 test case from XTOOL team,here show the guide on
how to use XTOOL PS90 perform headlight initialization for BMW X3 F25 2015.
Procedures:
Connect XTOOLPS90 to the vehicle
Select the Europe region
Tap BMW
Tap “Automatic selection”
Model series:X’_F25
Model:X3 20Ix_N20
Version:EUR_LL
Model year:2015_08
Vehicle ident.number:WBAWX3102G0L60271
Click “Yes” to continue
Select “Service” option on the Main menu
Select “Body”
Select “Lights”
Initialize headlight driver module
Select “Initialize new headlight driver
module and teach-in turn indicator”
It will prompt you that “Does the car
belong to America ares?”
Tap “Yes” to continue
The following related fault codes are
stored in the DME,click “OK” to continue
The TMS on the left-hand side has been
initialized,click “OK” to continue
It will prompt you with “The TMS on the
right-hand side has been initialized”,click “OK” to continue
The calibration of the LED lights in the left headlight has been started and
takes approx.10 seconds.Tap “OK” to continue
The calibration of the LED lights in the right headlight has been started and
takes approx.10 seconds.Tap “OK” to continue
The headlight driver module (TMS) can be
tested in the following way:
Switch on ignition
Switch the lights off and on
A reference run must be visible
If the reference run is not visible the
procedure must be performed again.
Tap “OK” to continue
Tap “OK” to end service function
No comments:
Post a Comment